Refer to the exhibit. A network engineer has been given the network address of 192.168.99.0 and a subnet mask of 255.255.255.192 to subnet across the four networks shown. How many total host addresses are unused across all four subnets?

Refer to the exhibit. A network engineer has been given the network address of 192.168.99.0 and a subnet mask of 255.255.255.192 to subnet across the four networks shown. How many total host addresses are unused across all four subnets? 158 200 224 88 72 Explanation: The network IP address 192.168.99.0 and a subnet mask of

The network administrator has deemed that 192.168.10.0/24 is to be the network used at this site. Which single subnet mask would make the most efficient use of the available addresses to use for the four subnetworks?

A network administrator wants to have the same network mask for all networks at a particular small site. The site has the following networks and number of devices:IP phones – 22 addresses PCs – 20 addresses needed Printers – 2 addresses needed Scanners – 2 addresses needed The network administrator has deemed that 192.168.10.0/24 is

Which subnet would include the address 192.168.1.96 as a usable host address?

Which subnet would include the address 192.168.1.96 as a usable host address? 192.168.1.32/27 192.168.1.32/28 192.168.1.64/29 192.168.1.64/26 Explanation: For the subnet of 192.168.1.64/26, there are 6 bits for host addresses, yielding 64 possible addresses. However, the first and last subnets are the network and broadcast addresses for this subnet. Therefore, the range of host addresses for

Refer to the exhibit. On the basis of the output, which two statements about network connectivity are correct? (Choose two.)

Refer to the exhibit. On the basis of the output, which two statements about network connectivity are correct? (Choose two.) This host does not have a default gateway configured. There are 4 hops between this device and the device at 192.168.100.1. The average transmission time between the two hosts is 2 milliseconds. There is connectivity

Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?

Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem? The entire command, configure terminal , must be used. The administrator must connect via the console port to access global configuration mode. The administrator is already in global configuration mode.

Which range of link-local addresses can be assigned to an IPv6-enabled interface?​

Which range of link-local addresses can be assigned to an IPv6-enabled interface?​ FE80::/10 FDEE::/7​ FF00::/8​ FEC0::/10​ Explanation: Link-local addresses are in the range of FE80::/10 to FEBF::/10. The original IPv6 specification defined site-local addresses and used the prefix range FEC0::/10, but these addresses were deprecated by the IETF in favor of unique local addresses. FDEE::/7

What happens when the transport input ssh command is entered on the switch vty lines?

What happens when the transport input ssh command is entered on the switch vty lines? The switch requires a username/password combination for remote access. The SSH client on the switch is enabled. Communication between the switch and remote users is encrypted. The switch requires remote connections via a proprietary client software. Answers Explanation & Hints: The transport