CCNA2 RSE v6.0 Final Exam Answers 2018 2019

CCNA2 RSE v6.0 Final Exam Answers 2018 2019 Media Description: A screen capture of configuration and verification commands is shown as follows:R1# configure terminal  Enter configuration commands, one per line.  End with CNTL/Z. R1(config)# ipv6 unicast-routing  R1(config)# ipv6 dhcp pool ACAD_CLASS  R1(config-dhcp)# dns-server 2001:db8:acad:a1::10  R1(config-dhcp)# domain-name netacad.net  R1(config-dhcp)# exit  R1(config)# interface gigabitEthernet 0/0  R1(config-if)# ipv6 […]
Continue reading…

 

CCNA2 v6.0 Practice Final Exam Answer 2017

CCNA2 v6.0 Practice Final Exam Answer 2017 CCNA2 v6.0 Practice Final The buffers for packet processing and the running configuration file are temporarily stored in which type of router memory? flash NVRAM RAM ROM What is the minimum configuration for a router interface that is participating in IPv6 routing? to have only a link-local IPv6 […]
Continue reading…

 

CCNA2 v6.0 Chapter 10 Exam Answers 2019

CCNA2 v6.0 Chapter 10 Exam Answers 2018 2019 A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to issue the show cdp neighbors command. Why would the network administrator issue this command if the ping failed between the two routers? The network administrator suspects a virus […]
Continue reading…

 

CCNA2 v6.0 Chapter 9 Exam Answers 2019

CCNA2 v6.0 Chapter 9 Exam Answers 2019 What is the primary purpose of NAT? conserve IPv4 addresses increase network security allow peer-to-peer file sharing enhance network performance Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts?​ It uses the destination TCP or UDP port number on the […]
Continue reading…

 

CCNA2 v6.0 Chapter 8 Exam Answers 2019

CCNA2 v6.0 Chapter 8 Exam Answers 2018 2019 Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is set as […]
Continue reading…

 

CCNA2 v6.0 Chapter 7 Exam Answers 2019

CCNA2 v6.0 Chapter 7 Exam Answers 2018 2019 In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface when a router has more than one ACL when […]
Continue reading…

 

CCNA2 v6.0 Chapter 6 Exam Answers 2019

CCNA2 v6.0 Chapter 6 Exam Answers 2018 2019 What are three primary benefits of using VLANs? (Choose three.) security a reduction in the number of trunk links cost reduction end user satisfaction improved IT staff efficiency no required configuration Which type of VLAN is used to designate which traffic is untagged when crossing a trunk […]
Continue reading…

 

CCNA2 v6.0 Chapter 5 Exam Answers 2019

CCNA2 v6.0 Chapter 5 Exam Answers 2018 2019 Which interface is the default location that would contain the IP address used to manage a 24-port Ethernet switch? VLAN 1 Fa0/0 Fa0/1 interface connected to the default gateway VLAN 99 A production switch is reloaded and finishes with a Switch> prompt. What two facts can be […]
Continue reading…

 

CCNA2 v6.0 Chapter 4 Exam Answers 2019

CCNA2 v6.0 Chapter 4 Exam Answers 2019 A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced cost for […]
Continue reading…

 

CCNA2 v6.0 Chapter 3 Exam Answers 2019

CCNA2 v6.0 Chapter 3 Exam Answers 2018 2019 Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP EIGRP OSPF RIP Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks? OSPF RIP EIGRP IS-IS What two tasks do dynamic routing protocols perform? (Choose […]
Continue reading…

 

CCNA2 v6.0 Chapter 2 Exam Answers 2019

CCNA2 v6.0 Chapter 2 Exam Answers 2019 What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it does not advertise over the network. Static routing scales well with expanding networks. Static routing requires very little knowledge of the network for correct implementation. Static routing uses fewer […]
Continue reading…

 

CCNA2 v6.0 Chapter 1 Exam Answers 2019

CCNA2 v6.0 Chapter 1 Exam Answers 2018 2019 A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into? flash RAM NVRAM ROM Which packet-forwarding method does a router use to make switching decisions when it is using a forwarding information base and an adjacency table? […]
Continue reading…

 

CCNA2 v6.0 ​​Pretest Exam Answer 2018

CCNA2 v6.0 ​​Pretest Exam Answer 2018 Which two components are configured via software in order for a PC to participate in a network environment? (Choose two.) MAC address IP address kernel shell subnet mask What is the correct order for PDU encapsulation? To revert to a previous configuration, an administrator issues the command copy tftp […]
Continue reading…