CCNA4 RSE Practice Skills Assessment – PT

CCNA4 RSE Practice Skills Assessment – PT CCNA4 RSE Practice Skills Assessment – PT, there are there types of this lab. You may find which one is your topology and then click on video to watch how to configure step by step to get full score 100%. Good Luck !!!! CCNA4 RSE Practice Skills Assessment..
Read More..

 

CCNA4 NB_ITN Practice Skills Assessment – PT

CCNA4 NB_ITN Practice Skills Assessment – PT CCNA4 NB_ITN Practice Skills Assessment – PT, there are three types of this lab. Please find which one is your topology type and then click on video. This video will guide you how to configure step by step to get full score 100%. CCNA4 NB_ITN Practice Skills Assessment..
Read More..

 

CCNA 4 Practice Final Exam Answer v5.02 2015 (100%)

CCNA 4 Practice Final Which three items are normally included when a log message is generated by a syslog client and forwarded to a syslog server? (Choose three.) date and time of message ID of sending device length of message message ID checksum field community ID Which WAN technology uses a fixed payload of 48..
Read More..

 

CCNA 4 Chapter 9 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 9 When should a network performance baseline be measured? during normal work hours of an organization immediately after the main network devices restarted after normal work hours to reduce possible interruptions when a denial of service attack to the network is detected and blocked A network engineer issues the show cdp neighbor..
Read More..

 

CCNA 4 Chapter 8 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 8 What are the most common syslog messages? those that occur when a packet matches a parameter condition in an access control list link up and link down messages output messages that are generated from debug output error messages about hardware or software malfunctions When logging is used, which severity level indicates..
Read More..

 

CCNA 4 Chapter 7 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 7 A network design engineer is planning the implementation of a cost-effective method to interconnect multiple networks securely over the Internet. Which type of technology is required? a GRE IP tunnel a leased line a VPN gateway a dedicated ISP What is one benefit of using VPNs for remote access? lower protocol..
Read More..

 

CCNA 4 Chapter 6 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 6 What are two disadvantages of employing teleworkers in an organization? (Choose two.)​ increased usage of sick or vacation days increased difficulty of tracking task progress slower customer service response times the need to implement a new management style increase in office expenses Which technology provides a secure connection between a SOHO..
Read More..

 

CCNA 4 Chapter 5 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 5 Typically, which network device would be used to perform NAT for a corporate environment? DHCP server host device router server switch What is the group of public IPv4 addresses used on a NAT-enabled router known as? outside local addresses inside local addresses inside global addresses outside global addresses When NAT is..
Read More..

 

CCNA 4 Chapter 4 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 4 What is a characteristic of Frame Relay that provides more flexibility than a dedicated line? Dedicated physical circuits are installed between each site. Customers use dedicated circuits in increments of 64 kb/s. The Frame Relay cloud allocates as much bandwidth as required to active PVCs to maintain the connection. One router..
Read More..

 

CCNA 4 Chapter 3 Exam Answer v5 & v5.02 2015 (100%)

CCNA 4 Chapter 3 At which layer of the OSI model does multiplexing take place? Layer 1 Layer 2 Layer 3 Layer 4 Which command can be used to view the cable type that is attached to a serial interface? Router(config)# show interfaces Router(config)# show controllers Router(config)# show ip interface Router(config)# show ip interface brief..
Read More..