CCNA3 v6.0 Chapter 1 Exam Full 100%

CCNA3 v6.0 Chapter 1 Exam Full 100%

  1. 1. Question
    What are two expected features of modern enterprise networks? (Choose two.)
  2. 2. Question
    What network design would contain the scope of disruptions on a network should a failure occur?
  3. 3. Question
    Which action should be taken when planning for redundancy on a hierarchical network design?
  4. 4. Question

    Refer to the exhibit. Which devices exist in the failure domain when switch S3 loses power?

    CCNA2 v6.0 Chapter 1 Exam 002

    CCNA2 v6.0 Chapter 1 Exam 002

  5. 5. Question
    Which design feature will limit the size of a failure domain in an enterprise network?
  6. 6. Question
    A network administrator is planning redundant devices and cabling in a switched network to support high availability. Which benefit will implementing the Spanning Tree Protocol provide to this design?
  7. 7. Question
    What are two benefits of extending access layer connectivity to users through a wireless medium? (Choose two.)
  8. 8. Question
    Which two features of enterprise class equipment assists an enterprise network in maintaining 99.999 percent up-time? (Choose two.)
  9. 9. Question
    What capability is provided by the use of application-specific integrated circuits in Cisco multilayer switches?
  10. 10. Question
    Which statement describes a characteristic of Cisco Meraki switches?
  11. 11. Question
    In which situation would a network administrator install a Cisco Nexus Series or Cisco Catalyst 6500 Series switch to promote infrastructure scalability?
  12. 12. Question
    Which statement describes a characteristic of Cisco Catalyst 2960 switches?
  13. 13. Question
    What are three access layer switch features that are considered when designing a network? (Choose three.)
  14. 14. Question
    What are two functions of a router? (Choose two.)
  15. 15. Question
    A network engineer is reviewing a network design that uses a fixed configuration enterprise router that supports both LAN and WAN connections. However, the engineer realizes that the router does not have enough interfaces to support growth and network expansion. Which type of device should be used as a​​ replacement?
  16. 16. Question
    When a Cisco IOS device is being selected or upgraded, which option indicates the capabilities of the Cisco IOS device?
  17. 17. Question
    Immediately after a router completes its boot sequence, the network administrator wants to check the routers configuration. From privileged EXEC mode, which of the following commands can the administrator use for this purpose? (Choose two.)
  18. 18. Question

    Refer to the exhibit. Which command was issued on a Cisco switch that resulted in the exhibited output?

    CCNA2 v6.0 Chapter 1 Exam 001

    CCNA2 v6.0 Chapter 1 Exam 001

  19. 19. Question
    What is a characteristic of in-band device management?
  20. 20. Question
    Which two requirements must always be met to use in-band management to configure a network device? (Choose two.)
  21. 21. Question
    Which type of information is displayed by the show ip protocols command that is issued from a router command prompt?
  22. 22. Question
    A network technician needs to connect a PC to a Cisco network device for initial configuration. What is required to perform this device configuration?
  23. 23. Question

    Match the purpose to the related configuration item. (Not all options are used.)

    • CCNA3 v6.0 Chapter 1 Exam 01CCNA3 v6.0 Chapter 1 Exam 01

Comments

comments